Experienced Board Power Designer

Responsibilities

Board power solution and design for radio products, Baseband products and network router products; DCDC power solution design, including lightning protection, polarity protection, hot-swap, EMC filter, power stage and control loop design; Circuit simulation, power loss calculation and margin analysis; Isolated and non-isolated DCDC design, task force driving, performance improvement and verification; Schematic design, and Layout Design (guiding PCB engineer to do Placement and Routing); Document preparation, Sch, layout, margin analysis, signal plan, verification plan/report; Released products maintenance and root cause analysis

Requirements

Bachelor or above in Electronic Engineering, Electrical Engineering, or Automation Major; Familiar with at least one of below converters: BUCK, BOOST, BUCK/BOOST, FLYBACK, Forward, Half-bridge, Full-bridge; Good communication and proactive attitude to cooperate with other function teams (HW, Digital, Mechanics, thermal, SW design teams); On-hand skill in using lab equipment: DC source, Oscilloscope, Electrical load, LISN, Loop analyzer, etc.; “Can-do” attitude for challenges and technical problems; Collaborate effectively within a cross-functional team; CET-6 or above. Proficient in spoken and written English

Nice to have

Experience on Electronics components reliability control and failure analysis; Knowledgeable on Semiconductor packaging technology and process